QuicPlate – Flat Plate Dowel System

Flat Plate Dowel System

QuicPlate Dowel

  • Increased capacity at wider joints openings provided by the same thickness and  width of the plate throughout the length of the plate.
  • Round dowels have been conventional load transfer device, but with this flat plate device ability to have a reduced bearing stress when compared. Round Dowels will become a thing of the past.
  • Engineered for optimal performance

QuicPlate Sleeve

  • Durable ABS
  • Wider Sleeve for increased lateral movement to prohibit lateral restraint
  • Ribs on the sleeve increase the rigidity of the sleeve
  • Internal Supports prevent the sleeve compressing during installation allowing easy and accurate insertion of the steel plate.

Spec Sheet


  • Eliminates drilling forms and greasing dowels
  • Don’t have to worry about misaligned dowels resulting in slab lockup which can cause cracking
  • Preset nails for quick and easy installation
  • Improved job site access with shorter dowels and bright colored sleeves
  • Less Hazards = Less On-Site Accidents = Faster Installation Time = Less Labor Cost
Based on spacing recommendations in conformance with ACI 360R-10
Slab Depth QuicPlate Flat Plate Dowel Dimensions Spacing
5″-6″ 1/4″ x 4″ x 6″ 18″
7″-8″ 3/8″ x 4″ x 6″ 18″
9″-12″ 3/4″ x 4″ x 6″ 18″
 Note: Information above is based on a maximum joint opening of 0.20″

QuicPlate_install_on_formwork2 QuicPlate_install_on_formwork
QuicPlate_being_install2 QuicPlate